R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

2
View
Ethernet interface view, Ethernet subinterface view
Default level
2: System level
Parameters
None
Description
Use default to restore the default settings for an Ethernet interface or subinterface.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. You can use the display this command in interface view to check
for these commands, and perform their undo forms or follow the command reference to individually
restore their default settings. If your restoration attempt still fails, follow the error message to resolve the
problem.
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you perform it on a live network.
Examples
# Restore the default settings for interface GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] default
This command will restore the default settings. Continue? [Y/N]:y
# Restore the default settings for subinterface GigabitEthernet 0/1.1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1.1
[Sysname-GigabitEthernet0/1.1] default
This command will restore the default settings. Continue? [Y/N]:y
description
Syntax
description text
undo description
View
Ethernet interface view, Ethernet subinterface view
Default level
2: System level
Parameters
text: Specifies the interface description, a string of 1 to 80 characters. The string can include
case-sensitive letters, digits, special characters (including ~ ! @ # $ % ^ & * ( ) - _ + = { } [ ] | \ : ; " '
< > , . /), spaces, and other Unicode characters and symbols.