R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

262
View
RIP view
Default level
2: System level
Parameters
None
Description
Use host-route to enable host route reception.
Use the undo host-route command to disable host route reception.
By default, receiving host routes is enabled.
In some cases, a router may receive many host routes from the same network segment. These routes are
not helpful for routing and occupy a large amount of network resources. Use undo host-route to disable
receiving of host routes.
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] undo host-route
import-route (RIP view)
Syntax
import-route protocol [ process-id | all-processes | allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
undo import-route protocol [ process-id ]
View
RIP view
Default level
2: System level
Parameters
protocol: Specifies a routing protocol from which to redistribute routes. It can be bgp, direct, isis, ospf,
rip, or static.
process-id: Process ID, in the range of 1 to 65535. The default is 1. It is available only when the protocol
is isis, rip, or ospf.
all-processes: Enables route redistribution from all the processes of a protocol. This keyword takes effect
only when the protocol is isis, rip, or ospf.
allow-ibgp: When the protocol argument is set to bgp, allow-ibgp is an optional keyword.
cost: Cost for redistributed routes, in the range of 0 to 16. If cost is not specified, the default cost specified
by the default cost command applies.