R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

266
You need not use the peer ip-address command when the neighbor is directly connected; otherwise the
neighbor may receive both the unicast and multicast (or broadcast) of the same routing information.
Examples
# Specify to send unicast updates to peer 202.38.165.1.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] peer 202.38.165.1
preference
Syntax
preference [ route-policy route-policy-name ] value
undo preference [ route-policy ]
View
RIP view
Default level
2: System level
Parameters
route-policy-name: Routing policy name with 1 to 63 case-sensitive characters.
value: Preference for RIP routes, in the range of 1 to 255. The smaller the value, the higher the preference.
Description
Use preference to specify the preference for RIP routes.
Use undo preference to restore the default.
By default, the preference of RIP routes is 100.
You can specify a routing policy by using the keyword route-policy to set a preference for the matching
RIP routes.
• The preference set by the routing policy applies to all matching RIP routes. The preference of other
routes is set by the preference command.
• If no preference is set by the routing policy, the preference of all RIP routes is set by the preference
command.
Examples
# Set the RIP route preference to 120.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120
reset rip process
Syntax
reset rip process-id process