R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

273
[Sysname] ip ip-prefix 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy] if-match ip-prefix 123
[Sysname-route-policy] apply cost 6
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] rip metricout route-policy abc 2
rip mib-binding
Syntax
rip mib-binding process-id
undo rip mib-binding
View
System view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use rip mib-binding to bind MIB operations with a specified RIP process, so that the RIP process can
receive SNMP requests.
Use undo rip mib-binding to restore the default.
By default, MIB operations are bound to RIP process 1. RIP process 1 is enabled to receive SNMP
requests.
Examples
# Enable RIP process 100 to receive SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding
rip output
Syntax
rip output
undo rip output
View
Interface view
Default level
2: System level