R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

8
0 CRC, 0 frame, 0 overruns, 0 aborts
0 ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, 0 underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, 0 no carrier
Table 3 Command output
Field Descri
p
tion
GigabitEthernet0/1 current state
Physical state of the Ethernet interface. For more information, see Table
4.
IP Packet Frame Type Ethernet framing format on the interface.
Description Description of the interface.
Loopback Loopback testing status of the interface.
100Mbps-speed mode, half-duplex
mode
The interface operates at 100 Mbps and in half duplex mode.
Link speed type is autonegotiation The interface will negotiate a speed with its peer.
link duplex type is autonegotiation The interface will negotiate a duplex mode with its peer.
The Maximum Frame Length The maximum Ethernet frame length allowed on the interface.
Broadcast MAX-ratio
Broadcast suppression threshold as a percentage of the interface
transmission capability. When the threshold is exceeded, the interface
drops broadcast packets.
Unicast MAX-ratio
Unknown unicast suppression threshold as a percentage of the
interface transmission capability. When the threshold is exceeded, the
interface drops unknown unicast packets.
Multicast MAX-ratio
Multicast suppression threshold as a percentage of the interface
transmission capability. When the threshold is exceeded, the interface
drops multicast packets.
PVID Port VLAN ID.
Mdi type Cable type.
Port link-type Link type of the interface, which could be access, trunk, and hybrid.
Tagged VLAN ID
VLANs for which the interface sends packets without removing VLAN
tags.
Untagged VLAN ID
VLANs for which the interface sends packets after removing VLAN
tags.
Last clearing of counters: Never
Time when the reset counts interface command was last used to clear
statistics on the interface. Never indicates that the reset counts
interface command was never used since the device was started.
Peak value of input Peak value of inbound traffic, in bytes/sec.
Peak value of output Peak value of outbound traffic, in bytes/sec.