R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

326
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Sysname-ospf-100-area-0.0.0.1] authentication-mode md5
[Sysname-ospf-100-area-0.0.0.1] quit
[Sysname-ospf-100] quit
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ospf authentication-mode md5 15 cipher abc
# Configure the network 131.119.0.0/16 in Area 1 to support simple authentication, and set for the
interface the authentication password to abc, and password type to cipher.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Sysname-ospf-100-area-0.0.0.1] authentication-mode simple
[Sysname-ospf-100-area-0.0.0.1] quit
[Sysname-ospf-100] quit
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ospf authentication-mode simple cipher abc
ospf bfd enable
Syntax
ospf bfd enable [ echo ]
undo ospf bfd enable
View
Interface view
Default level
2: System level
Parameters
echo: Configures BFD echo packet single-hop detection. If this keyword is not specified, BFD control
packet bidirectional detection is enabled.
Description
Use ospf bfd enable command to enable BFD for link failure detection on an OSPF interface.
Use undo ospf bfd enable command to disable BFD on an OSPF interface.
By default, an OSPF interface is not enabled with BFD.
The following matrix shows the command and firewall compatibility:
Command F1000-A-EI/S-EI F1000-E F5000 Firewall module
ospf bfd enable No No Yes No