R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

15
Field Descri
p
tion
Duplex
Duplex mode of the interface:
• A—Auto-negotiation
• F—Full duplex
• F(a)—Auto-negotiated full duplex
• H—Half duplex
• H(a)—Auto-negotiated half duplex
Type
Link type of the interface:
• A—Access
• H—Hybrid
• T—Trunk
PVID Port VLAN ID.
Cause
Causes for the physical state of an interface to be DOWN. For more information,
see Table 7.
Table 7 Command output
Field Descri
p
tion
Not connected
No physical connection exists (possibly because the network cable is
disconnected or faulty).
Administratively
The port was shut down with the shutdown command. To restore the physical
state of the interface, use the undo shutdown command.
Link-Aggregation interface
down
The aggregate interface corresponding to the aggregation group to which the
interface belongs was shut down with the shutdown command.
OAM connection failure
OAM connection fails (possibly because the connection fails to be established
or the connection is disconnected).
DLDP connection failure
DLDP connection fails (possibly because the connection fails to be established
or the connection is disconnected).
Loopback detection-protected The interface is shut down because a loop is detected on it.
BPDU-protected The interface is shut down by the BPDU guard function.
Monitor-Link uplink down The uplink of the monitor link group to which the interface belongs is down.
duplex
Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet interface view
Default level
2: System level