R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

383
By default, BGP does not redistribute routes from other protocols.
Only active routes can be redistributed. You can use the display ip routing-table protocol command to
display route state information.
The ORIGIN attribute of routes redistributed with the import-route command is incomplete.
The following matrix shows the argument and firewall compatibility:
Ar
g
ument F1000-A-EI/S-EI F1000-E F5000 Firewall module
protocol
Yes.
Excludes isis.
Yes.
Excludes isis.
Yes.
Includes isis.
Yes.
Excludes isis.
Examples
# In BGP view, redistribute routes from RIP.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] import-route rip
# In BGP-VPN instance view, redistribute routes from RIP (the VPN has been created).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] import-route rip
log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
BGP view
Default level
2: System level
Parameters
None
Description
Use log-peer-change to enable the global BGP logging on peers going up and down.
Use undo log-peer-change to disable the function.
By default, the function is enabled.
Examples
# Enable BGP logging on peers going up and down.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] log-peer-change