R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

17
Examples
# Enable TxRx mode generic flow control on the interface GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] flow-control
interface
Syntax
interface interface-type { interface-number | interface-number.subnumber }
View
System view
Default level
2: System level
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
interface-number.subnumber: Specifies a subinterface number, where interface-number is an interface
number, and subnumber is the number of a subinterface created under the interface. The subnumber
argument ranges from 1 to 4094.
Description
Use interface to enter interface or subinterface view. With the interface-number.subnumber argument
specified, if the subinterface identified by the argument does not exist, this command creates the
subinterface first, and then enters subinterface view.
Examples
# Enter GigabitEthernet 0/1 interface view (assuming that the interface is a Layer 2 Ethernet interface).
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1]
# Create Ethernet subinterface GigabitEthernet 0/1.1 and enter GigabitEthernet 0/1.1 subinterface view
(assuming that GigabitEthernet 0/1 is a Layer 2 Ethernet interface and the subinterface does not exist).
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1.1
[Sysname-GigabitEthernet0/1.1]
# Enter GigabitEthernet 0/1 interface view (assuming that the interface is a Layer 3 Ethernet interface).
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1]
# Create Ethernet subinterface GigabitEthernet 0/1.1 and enter GigabitEthernet 0/1.1 subinterface view
(assuming that GigabitEthernet 0/1 is an Layer 3 Ethernet interface and the subinterface does not exist).
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1.1
[Sysname-GigabitEthernet0/1.1]