R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

457
undo isis dis-name
View
Interface view
Default level
2: System level
Parameters
symbolic-name: Specifies a DIS name, a string of 1 to 64 characters.
Description
Use isis dis-name to configure a name for a DIS to represent the pseudo node on a broadcast network.
Use undo isis dis-name to remove the configuration.
No name is configured for the DIS by default.
This command takes effect only on a router that must have dynamic system ID to host name mapping
enabled. This command is not supported on a Point-to-Point interface.
NOTE:
This command is not available in loopback interface view.
Examples
# Configure the DIS name as LOCALAREA.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/2
[Sysname-GigabitEthernet4/2] isis dis-name LOCALAREA
isis dis-priority
Syntax
isis dis-priority value [ level-1 | level-2 ]
undo isis dis-priority [ value ] [ level-1 | level-2 ]
View
Interface view
Default level
2: System level
Parameters
value: Specifies a DIS priority for the interface, ranging from 0 to 127.
level-1: Applies the DIS priority to Level-1.
level-2: Applies the DIS priority to Level-2.
Description
Use isis dis-priority to specify a DIS priority at a specified level for an interface.
Use undo isis dis-priority to restore the default priority of 64 for Level-1 and Level-2.