R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

465
[Sysname] interface gigabitethernet4/2
[Sysname-GigabitEthernet4/2] isis timer lsp 500
isis timer retransmit
Syntax
isis timer retransmit seconds
undo isis timer retransmit
View
Interface view
Default level
2: System level
Parameters
seconds: Specifies the interval in seconds for retransmitting LSP packets, ranging from 1 to 300.
Description
Use isis timer retransmit to configure the interval for retransmitting LSP packets over a point-to-point link.
Use undo isis timer retransmit to restore the default.
By default, the retransmission interval is 5 seconds.
A P2P link requires a response to a sent LSP. If no response is received within the retransmission interval,
the LSP is retransmitted.
You need not use this command over a broadcast link where CNSPs are broadcast periodically.
Related commands: isis timer lsp.
NOTE:
• This command is not available in loopback interface view.
• Configure a proper retransmission interval to avoid unnecessary retransmissions.
• Perform this configuration only when the link layer protocol is PPP.
Examples
# Configure the LSP retransmission interval as 10 seconds for GigabitEthernet 4/2.
<Sysname> system-view
[Sysname] interface gigabitethernet4/2
[Sysname-GigabitEthernet4/2] isis timer retransmit 10
is-level
Syntax
is-level { level-1 | level-1-2 | level-2 }
undo is-level
View
IS-IS view