R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

516
Field Descri
p
tion
Referenced route/mask Referenced route and its mask length
Referenced route type
Type of the referenced route, which can be any of the following:
• igp—Unicast route (IGP)
• egp—Unicast route (EGP)
• unicast (direct)—Unicast route (directly connected)
• unicast—Other unicast route (such as unicast static route)
• mbgp—MBGP route
• static multicast—Static multicast route
Route selection rule
Rule for RPF route selection, which can be based on the preference of the
routing protocol or based on the longest match on the destination address
Load splitting rule Status of the load splitting rule (enabled/disabled)
ip rpf-route-static
Syntax
ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ] [ route-policy
policy-name ] { rpf-nbr-address | interface-type interface-number } [ preference preference ] [ order
order-number ]
undo ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ] [ route-policy
policy-name ]
View
System view
Default level
2: System level
Parameters
source-address: Multicast source address.
mask: Mask of the multicast source address.
mask-length: Mask length of the multicast source address, in the range of 0 to 32.
protocol: Routing protocol, which can have any of the following values:
• bgp: Specifies the BGP protocol.
• ospf: Specifies the OSPF protocol.
• rip: Specifies the RIP protocol.
• static: Specifies a static route.
process-id: Process number of the unicast routing protocol, in the range of 1 to 65535. This argument
must be provided if OSPF or RIP is the specified unicast routing protocol.
policy-name: Name of the routing policy used for matching static multicast routes, a case-sensitive string
of 1 to 63 characters.
rpf-nbr-address: Specifies an RPF neighbor by the IP address.