R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

517
interface-type interface-number: Specifies an RPF neighbor by providing the type and number of the
interface connecting the RPF neighbor.
preference: Route preference, in the range of 1 to 255 and defaulting to 1.
order-number: Match order for routes on the same segment, in the range of 1 to 100.
Description
Use ip rpf-route-static to configure a static multicast route.
Use undo ip rpf-route-static to delete a static multicast route from the static multicast routing table.
By default, no static multicast route is configured.
The arguments source-address { mask | mask-length }, protocol and policy-name are critical elements in
static multicast route configuration. The variation of any of these arguments results in a different
configuration.
All firewalls do not support the ISIS protocol for configuring static multicast routes.
When you configure a static multicast route, the system first checks whether any of these argument exists.
If the system finds a match, you must modify the corresponding fields without changing the configuration
sequence. Otherwise, the system adds a static multicast route.
When you configure a static multicast route, specify an RPF neighbor only by providing its IP address
(rpf-nbr-address) rather than providing the type and number (interface-type interface-number) of the
interface connecting the RPF if the interface of the RPF neighbor is a Layer 3 Ethernet interface, Layer 3
aggregate interface, Loopback interface, Layer 3 RPR logical interface, or VLAN interface.
Because outgoing interface iteration might fail or the specified interface might be in the down state, the
static multicast route configured with this command might fail to take effect. Therefore, use the display
multicast routing-table static command after you configure a static multicast route to check whether the
route has been successfully configured or whether the route has taken effect.
Related commands: delete ip rpf-route-static and display multicast routing-table static.
Examples
# Configure a static multicast route to the multicast source 10.1.1.1/24, specifying a router with the IP
address of 192.168.1.23 as its RPF neighbor.
<Sysname> system-view
[Sysname] ip rpf-route-static 10.1.1.1 24 192.168.1.23
mtracert
Syntax
mtracert source-address [ [ last-hop-router-address ] group-address ]
View
Any view
Default level
1: Monitor level
Parameters
source-address: Specifies a multicast source address.
group-address: Specifies a multicast group address, in the range of 224.0.1.0 to 239.255.255.255.