R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

32
Table 8 Command output
Field Descri
p
tion
current state Physical state (up or administratively down) of the interface
Line protocol current state
State of the data link layer protocol: up (spoofing). Spoofing
refers to the spoofing attribute of the interface. When the network
layer protocol state of the interface is displayed as up, the
corresponding link may not exist, or the corresponding link is
non-permanent and established on demand.
Description Description string of the interface
The Maximum Transmit Unit Maximum transmit unit (MTU) of the interface
Internet protocol processing
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary)
Physical is loopback The physical type of the interface is loopback
Last clearing of counters
Time when statistics on the logical interface were last cleared by
using the reset counters interface command.
If the statistics of the interface have never been cleared by using
the reset counters interface command since the firewall started,
Never is displayed for this field.
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average input rate during the last 300 seconds:
• packets/sec—The average number of packets received per
second.
• bytes/sec—The average number of bytes received per
second.
• bits/sec—The average number of bits received per second.
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average output rate over the last 300 seconds:
• packets/sec—Average number of packets sent per second.
• bytes/sec—Average number of bytes sent per second.
• bits/sec—Average number of bits sent per second.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the input packets of the
interface and the number of the dropped packets
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the output packets of the
interface and the number of the dropped packets
The brief information of interface(s) under
route mode
Brief information about Layer 3 interfaces
Link: ADM - administratively down; Stby -
standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To see
the primary interface, use the display standby state command.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP,
but its link is an on-demand link or not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name