R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

589
jp-queue-size (PIM view)
Syntax
jp-queue-size queue-size
undo jp-queue-size
View
Public network PIM view
Default level
2: System level
Parameters
queue-size: Maximum number of (S, G) entries in a join/prune message, in the range of 1 to 4,096.
Description
Use jp-queue-size to configure the maximum number of (S, G) entries in a join/prune message.
Use undo jp-queue-size to restore the default.
By default, a join/prune messages contains a maximum of 1,020 (S, G) entries.
When you use this command, take the following into account:
• The size of the forwarding table. In a network that does not support packet fragmentation, if you
configure a large queue-size, a join/prune message might contain a large number of groups,
causing the message length to exceed the MTU of the network. As a result, the products that do not
support fragmentation will drop the join/prune message.
• The (S, G) join/prune timeout time on the upstream device. If you configure a small queue size, the
outgoing interface of the corresponding entry might have been pruned due to timeout before the
last join/prune message in a queue reaches the upstream device.
Related commands: holdtime join-prune, jp-pkt-size, and pim holdtime join-prune.
Examples
# Configure a join/prune messages to contain a maximum of 2000 (S, G) entries in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] jp-queue-size 2000
pim
Syntax
pim
undo pim
View
System view
Default level
2: System level
Parameters
None