R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

47
Interface Link Protocol Main IP Description
Vlan2 DOWN DOWN --
# Display brief information for VLAN interfaces in DOWN state.
<Sysname> display interface vlan-interface brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Vlan2 DOWN Not connected
Table 11 Command output
Field Descri
p
tion
Vlan-interface2 current state
Physical state of a VLAN interface:
• DOWN ( Administratively )—The administrative state of the VLAN
interface is down, because it has been shut down with the
shutdown command.
• DOWN—The administrative sate of the VLAN interface is up, but its
physical sate is down. The VLAN corresponding to this interface
does not contain any physical port in the UP state (possibly because
the ports are not well connected or the lines have failed).
• UP—Both the administrative state and the physical state of the
VLAN interface are up.
Line protocol current state
Link layer protocol state of a VLAN interface:
• DOWN—The protocol state of the VLAN interface is down.
• UP—The protocol state of the VLAN interface is up.
Description Description string of a VLAN interface.
The Maximum Transmit Unit MTU of a VLAN interface.
Internet protocol processing :
disabled
The interface is not capable of processing IP packets. This information
is displayed when the interface is not configured with an IP address.
Internet Address is
192.168.1.54/24 Primary
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is configured for
the interface.
Internet Address is 6.4.4.4/24 Sub
The secondary IP address of the interface is 6.4.4.4/24. This
information is displayed only if a secondary IP address is configured
for the interface.
IP Packet Frame Type IPv4 outgoing frame format.
Hardware address MAC address corresponding to a VLAN interface.
IPv6 Packet Frame Type IPv6 outgoing frame format.
Last clearing of counters
Time when the reset counters interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device's startup.
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Average rate of input packets in the last 300 seconds (in bps and pps).
Last 300 seconds output: 0 bytes/sec
0 packets/sec
Average rate of output packets in the last 300 seconds (in bps and
pps).