R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

725
View
OSPFv3 view
Default level
2: System level
Parameters
area-id: ID of an area, a decimal integer (in the range of 0 to 4294967295 and changed to IPv4 address
format by the system) or an IPv4 address.
Description
Use area to enter OSPFv3 area view.
NOTE:
The undo form of the command is not available. An area is removed automatically if no configuration is
made and no interface is up in the area.
Examples
# Enter OSPFv3 Area 0 view.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0]
bandwidth-reference
Syntax
bandwidth-reference value
undo bandwidth-reference
View
OSPFv3 view
Default level
2: System level
Parameters
value: Bandwidth reference value for link cost calculation, in the range of 1 to 2147483648 Mbps.
Description
Use bandwidth-reference to specify a reference bandwidth value for link cost calculation.
Use undo bandwidth-reference to restore the default value.
The default value is 100 Mbps.
You can configure an OSPFv3 cost for an interface with one of the following methods:
• Configure the cost value in interface view
• Configure a bandwidth reference value, and OSPFv3 computes the cost automatically based on the
bandwidth reference value: Interface OSPFv3 cost = Bandwidth reference value/Interface
bandwidth. If the calculated cost is greater than 65535, the value of 65535 is used.