R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

765
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] spf timers 6 6
stub (OSPFv3 area view)
Syntax
stub [ no-summary ]
undo stub
View
OSPFv3 area view
Default level
2: System level
Parameters
no-summary: This argument is only applicable to the ABR of a stub area. With it configured, the ABR
advertises only a default route in a Summary-LSA to the stub area (such an area is called a totally stub
area).
Description
Use stub to configure an area as a stub area.
Use undo stub to remove the configuration.
By default, an area is not configured as a stub area.
When an area is configured as a stub area, all the routers attached to the area must be configured with
the stub command.
Related commands: default-cost.
Examples
# Configure OSPFv3 area 1 as a stub area.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
vlink-peer (OSPFv3 area view)
Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds | dead seconds |
instance instance-id | ipsec-policy policy-name ] *
undo vlink-peer router-id [ hello | retransmit | trans-delay | dead | ipsec-policy ] *
View
OSPFv3 area view
Default level
2: System level