R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

60
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk permit vlan 2
Please wait... Done.
Configuring GigabitEthernet0/1... Done.
Configuring GigabitEthernet0/2... Done.
Configuring GigabitEthernet0/3... Done.
The output shows that GigabitEthernet 0/1, GigabitEthernet 0/2, and GigabitEthernet 0/3 are the
member ports of the aggregation group corresponding to Bridge-Aggregation 1.
port trunk pvid
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, ranging from 1 to 4094
Description
Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
By default, the PVID of a trunk port is VLAN 1.
You can use a nonexistent VLAN as the PVID for a trunk port. If you remove the PVID of a trunk port with
the undo vlan command, it does not affect the setting of the PVID on the port.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted
properly.
You must use the port trunk permit vlan command to configure the trunk port to allow and forward
packets from the PVID.
Related commands: port link-type and port trunk permit vlan.
Examples
# Configure VLAN 100 as the PVID of the trunk port GigabitEthernet 0/1.