R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

827
View
IPv6 address family view, IPv6 BGP-VPN instance view
Default level
2: System level
Parameters
external-preference: Preference of EBGP route learned from an EBGP peer, in the range of 1 to 255.
internal-preference: Preference of IBGP route learned from an IBGP peer, in the range of 1 to 255.
local-preference: Preference of IPv6 BGP local route, in the range of 1 to 255.
route-policy-name: Routing policy name, a string of 1 to 63 characters. The routing policy can set a
preference for routes passing it. The default value applies to the routes filtered out.
Description
Use preference to configure preferences for EBGP, IBGP, and local routes.
Use undo preference to restore the default.
The bigger the preference value is, the lower the preference is. The default values of external-preference,
internal-preference and local-preference are 255, 255 and 130 respectively.
Examples
# Configure preferences for EBGP, IBGP, and local routes as 20, 20 and 200.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] preference 20 20 200
reflect between-clients
Syntax
reflect between-clients
undo reflect between-clients
View
IPv6 address family view
Default level
2: System level
Parameters
None
Description
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects routes between clients. If the clients are fully meshed, HP
recommends disabling route reflection on the route reflector to reduce costs.