R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

857
IPv6 policy-based routing configuration
commands
apply default output-interface
Syntax
apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
View
IPv6 PBR policy node view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface.
Description
Use apply default output-interface to set a default outgoing interface for IPv6 packets.
Use undo apply default output-interface to remove the default outgoing interface.
This command only applies to packets not finding a match in the routing table. You can specify up to five
default outgoing interfaces for per-flow load balancing.
Using the undo apply default output-interface command with an interface specified removes the default
outgoing interface. Using this command without any interface specified removes all default outgoing
interfaces.
Examples
# Set the default outgoing interface to GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply default output-interface gigabitethernet 0/1
apply ipv6-address default next-hop
Syntax
apply ipv6-address default next-hop ipv6-address
undo apply ipv6-address default next-hop [ ipv6-address ]
View
IPv6 PBR policy node view
Default level
2: System level