R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

860
View
IPv6 PBR policy node view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface.
Description
Use apply output-interface to set an outgoing interface.
Use undo apply output-interface to remove the clause.
Five outgoing interfaces at most can be specified for per-flow load sharing.
For non-P2P interfaces (broadcast and NBMA interfaces) such as Ethernet interfaces, multiple next hops
are available, and packets may not be forwarded successfully.
Using the undo apply output-interface command with an interface specified removes the outgoing
interface. Using this command without any interface specified removes all outgoing interfaces.
Examples
# Specify the interface GigabitEthernet 0/1 as the outgoing interface.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply output-interface gigabitethernet 0/1
display ipv6 config policy-based-route
Syntax
display ipv6 config policy-based-route [ policy-name ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
policy-name: Policy name, a string of 1 to 19 characters.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Getting Started Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use display ipv6 config policy-based-route to display the IPv6 PBR policy information.