R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

64
MAC address table configuration commands
NOTE:
• The MAC address table can contain only Layer 2 Ethernet ports and Layer 2 aggregate interfaces.
• This document covers only the configuration of unicast MAC address table entries, including static,
dynamic, and blackhole MAC address table entries. For more information about configuring static
multicast MAC address table entries, see
Network Management Configuration Guide .
display mac-address
Syntax
display mac-address [ mac-address [ vlan vlan-id ] | [ [ dynamic | static ] [ interface interface-type
interface-number ] | blackhole ] [ vlan vlan-id ] [ count ] ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
blackhole: Displays destination blackhole MAC address entries. These entries do not age, but you can
add or remove them. Packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
vlan vlan-id: Displays MAC address entries of the specified VLAN, where vlan-id ranges from 1 to 4094.
count: Displays the number of MAC address entries specified by related parameters in the command.
When this keyword is used, the command displays only the number of specified MAC address entries,
rather than related information about these MAC address entries.
mac-address: Displays MAC address entries of a specified MAC address, in the format of H-H-H.
dynamic: Displays dynamic MAC address entries. Aging time is set for these entries.
static: Displays static MAC address entries. Similar to blackhole MAC address entries, these entries do
not age, but you can add or remove them.
interface interface-type interface-number: Displays the MAC address learning status of the specified
interface. interface-type interface-number specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Getting Started Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.