R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

921
Description
Use pim ipv6 timer join-prune to configure on the current interface the interval at which join/prune
messages are sent.
Use undo pim ipv6 timer join-prune to restore the default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim ipv6 timer join-prune 80
pim ipv6 triggered-hello-delay
Syntax
pim ipv6 triggered-hello-delay interval
undo pim ipv6 triggered-hello-delay
View
Interface view
Default level
2: System level
Parameters
interval: Maximum delay in seconds between hello messages, with an effective range of 1 to 60.
Description
Use pim ipv6 triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim ipv6 triggered-hello-delay to restore the default.
By default, the maximum delay between hello messages is 5 seconds.
Examples
# Set the maximum delay between hello messages to 3 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim ipv6 triggered-hello-delay 3
probe-interval (IPv6 PIM view)
Syntax
probe-interval interval
undo probe-interval
View
IPv6 PIM view