R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

929
Description
Use state-refresh-interval to configure the interval between state refresh messages.
Use undo state-refresh-interval to restore the default.
By default, the state refresh interval is 60 seconds.
Related commands: pim ipv6 state-refresh-capable, state-refresh-hoplimit, and state-refresh-rate-limit.
Examples
# Set the state refresh interval to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70
state-refresh-rate-limit (IPv6 PIM view)
Syntax
state-refresh-rate-limit interval
undo state-refresh-rate-limit
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: Time to wait before receiving a new refresh message, in seconds and with an effective range of
1 to 65535.
Description
Use state-refresh-rate-limit to configure the time the router must wait before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
By default, the device waits 30 seconds before receiving a new state refresh message.
Related commands: pim ipv6 state-refresh-capable, state-refresh-hoplimit, and state-refresh-interval.
Examples
# Configure the device to wait 45 seconds before receiving a new state refresh message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-rate-limit 45
static-rp (IPv6 PIM view)
Syntax
static-rp ipv6-rp-address [ acl6-number ] [ preferred ]
undo static-rp ipv6-rp-address