R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

945
max-response-time (MLD view)
Syntax
max-response-time interval
undo max-response-time
View
MLD view
Default level
2: System level
Parameters
interval: Maximum response delay for MLD general query messages in seconds, in the range of 1 to 25.
Description
Use max-response-time to configure the maximum response delay for MLD general queries globally.
Use undo max-response-time to restore the default.
By default, the maximum response delay for MLD general queries is 10 seconds.
Related commands: display mld interface, mld max-response-time, and timer other-querier-present.
Examples
# Set the maximum response delay for MLD general queries to 8 seconds globally.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] max-response-time 8
mld
Syntax
mld
undo mld
View
System view
Default level
2: System level
Parameters
None
Description
Use mld to enter MLD view.
Use undo mld to remove the configurations made in MLD view.
This command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: mld enable and multicast ipv6 routing-enable.