R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

951
Parameters
None
Description
Use mld proxying enable to enable MLD proxying on an interface.
Use undo mld proxying enable to disable MLD proxying on the interface.
By default, MLD proxying is disabled.
This command takes effect only after IPv6 multicast routing is enabled.
If MLD proxying is enabled on a loopback interface, the proxy device maintains only the MLD routing
table without adding the MLD routes to the multicast routing table and forwarding table.
Related commands: multicast ipv6 routing-enable.
Examples
# Enable IPv6 multicast routing and enable MLD proxying on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mld proxying enable
mld proxying forwarding
Syntax
mld proxying forwarding
undo mld proxying forwarding
View
Interface view
Default level
2: System level
Parameters
None
Description
Use mld proxying forwarding to enable a non-querier downstream interface to forward multicast traffic.
Use undo mld proxying forwarding to disable the forwarding capability of a non-querier downstream
interface.
By default, a non-querier downstream interface does not forward multicast traffic.
Examples
# Enable the multicast forwarding capability on GigabitEthernet 0/1, a non-querier downstream
interface on the MLD proxy device.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mld proxying forwarding