R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

279
Table 53 Configuration items
Item Descri
p
tion
Interface Name
Specify the interface to which the policy is to be
applied.
Policy Name Select the QoS policy to be applied.
Direction
Specify the direction in which the policy is to be
applied.
• Inbound—Applies the policy to the incoming
packets on the specified interface.
• Outbound—Applies the policy to the outgoing
packets on the specified interface.
Configuring port bandwidth limit
Configuring port bandwidth limit is to set the maximum available bandwidth on a port. This setting is
used in place of actual physical port bandwidth for bandwidth check when CBQ enqueues packets.
If no maximum available bandwidth is configured for an interface, the bandwidth used for CBQ
calculation varies by the interface type following these rules:
• If the interface is a physical one, the actual baudrate or rate applies.
• If the interface is a template interface, a virtual template (VT) interface for example, 1000000 kbps
applies.
• If the interface is a virtual interface, a tunnel interface for example, 0 kbps applies.
Select Firewall > QoS > PortBandwidth from the navigation tree, and click Setup to enter the page for
configuring port bandwidth limit, as shown in Figure 185.
Figure 185 Port bandwidth