R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

339
Ste
p
Command Remarks
6. Configure the RIP interface to
advertise a default route.
rip default-route { { only | originate }
[ cost cost ] | no-originate }
Optional.
By default, a RIP interface can
advertise a default route if the
RIP process is configured with
default route advertisement.
NOTE:
The router enabled to advertise a default route does not receive default routes from RIP neighbors.
Configuring inbound/outbound route filtering
The device supports route filtering. You can filter routes by configuring the inbound and outbound route
filtering policies by referencing an ACL or IP prefix list. You can also configure the router to receive only
routes from a specified neighbor.
To configure route filtering:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure the filtering of
incoming routes.
filter-policy { acl-number | gateway
ip-prefix-name | ip-prefix
ip-prefix-name [ gateway
ip-prefix-name ] } import
[ interface-type interface-number ]
Not configured by default.
4. Configure the filtering of
outgoing routes.
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] | interface-type
interface-number ]
Not configured by default.
NOTE:
• Using the filter-policy import command filters incomin
g
routes. Routes not passin
g
the filterin
g
will be
neither installed into the routing table nor advertised to neighbors.
• Using the filter-policy export command filters outgoing routes, including routes redistributed with the
import-route command.
Configuring a priority for RIP
Multiple IGP protocols may run in a router. If you want RIP routes to have a higher priority than those
learned by other routing protocols, assign RIP a smaller priority value to influence optimal route selection.
To configure a priority for RIP:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A