R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

340
Ste
p
Command Remarks
3. Configure a priority for RIP.
preference [ route-policy
route-policy-name ] value
Optional.
100 by default.
Configuring RIP route redistribution
If a router runs RIP and other routing protocols, you can configure RIP to redistribute OSPF, BGP, static,
or direct routes.
To configure RIP route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a default metric for
redistributed routes.
default cost value
Optional.
The default metric of a
redistributed route is 0.
4. Redistribute routes from another
protocol.
import-route protocol [ process-id |
all-processes | allow-IBGP ] [ cost
cost | route-policy route-policy-name
| tag tag ] *
No redistribution is configured
by default.
NOTE:
Only active routes can be redistributed. Use the display ip routing-table protocol command to display
route state information.
Tuning and optimizing RIP networks
Before tuning and optimizing RIP networks, complete the following tasks:
• Configure network addresses for interfaces, and make sure that all neighboring nodes can reach
each other.
• Configure RIP basic functions.
Configuring RIP timers
You can change the RIP network convergence speed by adjusting RIP timers.
To configure RIP timers:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A