R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

343
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Enable source IP address
check on incoming RIP
messages.
validate-source-address
Optional.
Enabled by default.
NOTE:
The source IP address check feature should be disabled if the RIP neighbor is not directly connected.
Configuring RIPv2 message authentication
In a network requiring high security, you can configure this task to implement RIPv2 message validity
check and authentication.
RIPv2 supports two authentication modes: plain text and MD5.
In plain text authentication, the authentication information is sent with the RIP message; however, this
cannot meet high security needs.
To configure RIPv2 message authentication:
Ste
p
Command
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Configure RIPv2
authentication.
rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453
key-string } | simple password }
NOTE:
This feature does not apply to RIPv1 because RIPv1 does not support authentication. Although you can
specify an authentication mode for RIPv1 in interface view, the configuration does not take effect.
Specifying a RIP neighbor
Usually, RIP sends messages to broadcast or multicast addresses. On non broadcast or multicast links,
you need to manually specify RIP neighbors.
To specify a RIP neighbor:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a RIP neighbor.
peer ip-address N/A
4. Disable source address check
on incoming RIP updates.
undo validate-source-address Not disabled by default.