R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

412
# Configure Firewall B.
[FirewallB] interface GigabitEthernet 0/1
[FirewallB-GigabitEthernet0/1] ospf dr-priority 2
[FirewallB-GigabitEthernet0/1] quit
# Display information about neighbors on Router B.
<RouterB> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Neighbors
Area 0.0.0.0 interface 192.168.1.4(Ethernet1/1)'s neighbors
Router ID: 1.1.1.1 Address: 192.168.1.1 GR State: Normal
State: Full Mode:Nbr is Slave Priority: 100
DR: 192.168.1.4 BDR: 192.168.1.3 MTU: 0
Dead timer due in 31 sec
Neighbor is up for 00:11:17
Authentication Sequence: [ 0 ]
Router ID: 2.2.2.2 Address: 192.168.1.2 GR State: Normal
State: Full Mode:Nbr is Slave Priority: 0
DR: 192.168.1.4 BDR: 192.168.1.3 MTU: 0
Dead timer due in 35 sec
Neighbor is up for 00:11:19
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3 Address: 192.168.1.3 GR State: Normal
State: Full Mode:Nbr is Slave Priority: 2
DR: 192.168.1.4 BDR: 192.168.1.3 MTU: 0
Dead timer due in 33 sec
Neighbor is up for 00:11:15
Authentication Sequence: [ 0 ]
The DR and BDR are not changed, because the router priority settings do not take effect
immediately.
4. Restart the OSPF process:
# Restart the OSPF process on Router B. (Details not shown)
<RouterB> reset ospf 1 process
Warning : Reset OSPF process? [Y/N]:y
# Display neighbor information on Router B.
<RouterB> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Neighbors
Area 0.0.0.0 interface 192.168.1.4(Ethernet1/1)'s neighbors
Router ID: 1.1.1.1 Address: 192.168.1.1 GR State: Normal
State: Full Mode: Nbr is Slave Priority: 100
DR: 192.168.1.1 BDR: 192.168.1.3 MTU: 0