R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

41
Ste
p
Command Remarks
2. Enter interface view.
• Enter Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
Use either command.
• The configuration made in Ethernet
interface view applies only to the port.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its
aggregation member ports. If the
system fails to apply the configuration
to the aggregate interface, it stops
applying the configuration to
aggregation member ports. If the
system fails to apply the configuration
to an aggregation member port, it skips
the port and moves to the next member
port.
3. Configure the link type of
the ports as trunk.
port link-type trunk By default, all ports are access ports.
4. Assign the trunk ports to
the specified VLANs.
port trunk permit vlan
{ vlan-id-list | all }
By default, a trunk port carries only VLAN
1.
5. Configure the PVID of the
trunk ports.
port trunk pvid vlan vlan-id
Optional.
By default, the PVID is VLAN 1.
NOTE:
• To chan
g
e the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
• After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in Ethernet interface view or Layer
2 aggregate interface view.
To assign a hybrid port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A