R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

715
Ste
p
Command Remarks
2. Configure an IPv6 static
route.
• Approach 1:
ipv6 route-static ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
next-hop-address | vpn-instance
d-vpn-instance-name nexthop-address }
[ preference preference-value ]
• Approach 2:
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6>
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ preference preference-value ]
Use either approach.
The default preference
of IPv6 static routes is
60.
Displaying and maintaining IPv6 static routes
Task Command Remarks
Display IPv6 static route
information.
display ipv6 routing-table
[ vpn-instance vpn-instance-name ]
protocol static [ inactive | verbose ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Remove all IPv6 static routes.
delete ipv6 [ vpn-instance
vpn-instance-name ] static-routes
all
Available in system view
To remove one IPv6 static route, use the undo ipv6 route-static command to. To remove all IPv6 static
routes, including the default route, use the delete ipv6 static-routes all command.
For more information about display ipv6 routing-table [ vpn-instance vpn-instance-name ] protocol
static [ inactive | verbose ] [ | { begin | exclude | include } regular-expression ] command, see
"Displaying the IPv6 routing table."
IPv6 static routing configuration example
Network requirements
As shown in Figure 375, configure IPv6 static routes so that hosts can reach one another. The interfaces
of the firewalls use the IPv6 local link addresses.