R3721-F3210-F3171-HP High-End Firewalls Network Management Configuration Guide-6PW101

902
Ste
p
Command Remarks
6. Set a cost for routing
information.
apply cost [ + | - ] value
Optional.
Not set by default.
7. Set a cost type for routing
information.
apply cost-type [ external | internal
| type-1 | type-2 ]
Optional.
Not set by default.
Only F5000 supports the
external and internal keywords.
8. Set the next hop.
• Set the next hop for IPv4 routes:
apply ip-address next-hop
ip-address
• Set the next hop for IPv6 routes:
apply ipv6 next-hop
ipv6-address
Optional.
Not set by default.
The setting does not apply to
redistributed routing information.
9. Set the local preference for
BGP routing information.
apply local-preference preference
Optional.
Not set by default.
10. Set the origin attribute for BGP
routing information.
apply origin { egp as-number | igp
| incomplete }
Optional.
Not set by default.
11. Set the preference for the
routing protocol.
apply preference preference
Optional.
Not set by default.
12. Set a preferred value for BGP
routing information.
apply preferred-value
preferred-value
Optional.
Not set by default.
13. Set a tag value for RIP, OSPF or
IS-IS routing information
apply tag value
Optional.
Not set by default.
NOTE:
• The difference between IPv4 and IPv6 apply clauses is the command for settin
g
the next hop for routin
g
information.
• The apply ip-address next-hop and apply ipv6 next-hop commands do not apply to redistributed IPv4
and IPv6 routes respectively.
Defining a continue clause
Follow these guidelines when you define a continue clause:
• If you configure the same type of apply clauses that set different values (including the apply
community and apply extcommunity clauses with the additive keyword) on nodes that are
combined by the continue clause, the apply clause configured on the last matching node takes
effect.
• If you configure the apply community clause for multiple nodes that are combined by the continue
clause, the apply comm-list delete clause configured on the current node cannot delete the
community attributes of preceding nodes.
To define a continue clause: