R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

131
<Sysname> system-view
[Sysname] ntp-service authentication enable
[Sysname] ntp-service authentication-keyid 10 authentication-mode md5 BetterKey
ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
Interface view
Default level
3: Manage level
Parameters
None
Description
Use ntp-service broadcast-client to configure the device to operatein the NTP broadcast client mode and
use the current interface to receive NTP broadcast packets.
Use undo ntp-service broadcast-client to remove the configuration.
By default, the device does not operate in any NTP operation mode.
Examples
# Configure the device to operate in broadcast client mode and receive NTP broadcast messages on
GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] ntp-service broadcast-client
ntp-service broadcast-server
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default level
3: Manage level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to broadcast
clients, where keyid ranges from 1 to 4294967295. This parameter is not meaningful if authentication is
not required.
version number: Specifies the NTP version, where number ranges from 1 to 3 and defaults to 3.