R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

60
• Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This
equals execution of the commands patch location, patch load and patch active. The patches turn to
the DEACTIVE state after system reboot.
Before executing the command, save patch files to the specified directory.
After the patch install command is executed, the system changes the patch file location specified with the
patch location command to the directory specified by the patch-location argument of the patch install
command. For example, if you execute the patch location xxx command and then the patch install yyy
command, the patch file location automatically changes from xxx to yyy. If you execute the patch install
file filename command, the system will not change the patch file location.
In FIPS mode, the system examines the signature of the file. Only when the signature is OK, can the file
be used.
Examples
# Install the patches located on the Flash.
<Sysname> system-view
[Sysname] patch-install flash0:
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
Installing patches…
Installation completed, and patches will continue to run after reboot.
[Sysname]
patch load
Syntax
patch load
View
System view
Default level
3: Manage level
Parameters
None
Description
Use patch load to load the patch file on the storage media (including the Flash and the CF card) to the
memory patch area.
After you execute this command, the system first tries to read patch files from the Flash. If the attempt fails,
the system tries to read patch files from the CF card.
Before executing this command, save the patch files to the root directories of the storage medium.
In FIPS mode, the system examines the signatures of the patch files. Only when the signatures are OK,
can the files be used.
Examples
# Load the patch file from a patch file.
<Sysname> system-view
[Sysname] patch load