R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101
104
Ste
p
Command
Remarks
3. Configure the device to
operate in NTP multicast client
mode.
ntp-service multicast-client
[ ip-address ]
You can configure up to 1024 multicast
clients, among which 128 can take effect
at the same time.
Configuring the multicast server
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
This command enters the view of
the interface for sending NTP
multicast messages.
3. Configure the device to
operate in NTP multicast
server mode.
ntp-service multicast-server
[ ip-address ]
[ authentication-keyid keyid | ttl
ttl-number | version number ] *
A multicast server can synchronize
broadcast clients only when its
clock has been synchronized.
Configuring the local clock as a reference source
A network device can get its clock synchronized in one of the following ways:
• Synchronized to the local clock, which operates as the reference source.
• Synchronized to another device on the network in any of the four NTP operation modes.
If you configure two synchronization modes, the device selects the optimal clock as the reference source.
Typically, the stratum level of the NTP server which is synchronized from an authoritative clock (such as an
atomic clock) is set to 1. This NTP server operates as the primary reference source on the network; and
other devices synchronize themselves to it. The synchronization distances between the primary reference
source and other devices on the network, namely, the number of NTP servers on the NTP synchronization
paths, determine the clock stratum levels of the devices.
If you have configured the local clock as a reference clock, the local device can act as a reference clock
to synchronize other devices in the network. Therefore, perform this configuration with caution to avoid
clock errors of the devices in the network.
To configure the local clock as a reference source:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure the local clock as a
reference source.
ntp-service refclock-master
[ ip-address ] [ stratum ]
The ip-address argument must be
127.127.1.u, where u ranges from 0 to
3, representing the NTP process ID.