R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

156
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server.
[Firewall] ssh server enable
# Configure an IP address for interface GigabitEthernet 0/1, which the SSH client will use as the
destination for SSH connection.
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] ip address 192.168.1.40 255.255.255.0
[Firewall-GigabitEthernet0/1] quit
# Set the authentication mode for the user interfaces to AAA.
[Firewall] user-interface vty 0 4
[Firewall-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Firewall-ui-vty0-4] protocol inbound ssh
[Firewall-ui-vty0-4] quit
# Create local user client001, and set the user command privilege level to 3.
[Firewall] local-user client001
[Firewall-luser-client001] password simple aabbcc
[Firewall-luser-client001] service-type ssh
[Firewall-luser-client001] authorization-attribute level 3
[Firewall-luser-client001] quit
# Specify the service type for user client001 as Stelnet, and the authentication method as
password. This step is optional.
[Firewall] ssh user client001 service-type stelnet authentication-type password
2. Establish a connection between the SSH client and SSH server.
NOTE:
The device supports a variety of SSH client software, such as PuTTY, and OpenSSH. The following is an
example of configuring SSH client that uses PuTTY Version 0.58.
# Establish a connection to the SSH server.
Launch PuTTY.exe to enter the following interface. In the Host Name (or IP address) field, enter the
IP address of the server.