R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

36
• Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This
equals execution of the commands patch location, patch load and patch active. The patches turn to
the DEACTIVE state after system reboot.
To install the patches in one step:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Install the patches in one step.
patch install patch-location N/A
NOTE:
• The patch matches the card type and software version.
• To uninstall all patches in one operation, use the undo patch install command, which is the same as
performing Uninstalling a patch step by step.
Installing a patch step by step
Step-by-step patch installation enables you to control the patch status during the patch installation
process.
Step-by-step patch installation task list
Task Remarks
Configuring the patch file location
Optional.
To install a patch package, skip this step.
Loading a patch file Required.
Activating patches Required.
Confirming running patches Optional.
Configuring the patch file location
If you save the patch files to a storage medium other than the Flash, you must specify the directory that
saves patch files so the system can locate them.
If the device has only one storage medium, you do not need to perform this task.
To configure the patch file location:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the patch file
location.
patch location
patch-location
Optional.
By default, the patch file location is flash:.
NOTE:
A
fter you execute the patch install patch-location command, the directory specified for the patch-locatio
n
argument will replace the directory specified with the patch location command after the upgrade is
complete.