R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

38
Task Remarks
Stopping running patches Required
Deleting patches Required
Stopping running patches
When you stop running a patch, the patch state becomes DEACTIVE, and the system runs the way it did
before it was installed with the patch.
To stop running patches:
Ste
p
Command
1. Enter system view. system-view
2. Stop running patches.
patch deactive [ patch-number ]
Deleting patches
Deleting patches only removes the patches from the memory patch area, and does not delete them from
the storage media. The patches turn to IDLE state after this operation. After a patch is deleted, the system
runs the way it did before it was installed with the patch.
To delete patches:
Ste
p
Command
1. Enter system view.
system-view
2. Delete the specified patches from the memory
patch area.
patch delete [ patch-number ]
Displaying and maintaining software upgrade
Task Command Remarks
Display information about the
system software image.
display boot-loader [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display the patch information.
display patch information [ | { begin |
exclude | include } regular-expression ]
Available in any view
Software upgrade configuration examples
Scheduled upgrade configuration example
Network requirement
• As shown in Figure 18, the current software version is soft-version1 for the Firewall. Upgrade the
software version of the Firewall to soft-version2 and configuration file to new-config at a time when
few services are processed (for example, at 3 am) through remote operations.