R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

55
Severity Severity value Description
Corresponding keyword
in commands
Alert 1 Action must be taken immediately. alerts
Critical 2 Critical condition. critical
Error 3 Error condition. errors
Warning 4 Warning condition. warnings
Notice 5 Normal but significant condition. notifications
Informational 6 Informational messages. informational
Debug 7 Debug messages. debugging
Output channels and destinations
Table 7 shows the output channels and destinations.
The system supports ten channels. By default, channels 0 through 6, and channel 9 are configured with
channel names and output destinations. You can change these default settings as needed. You can also
configure channels 7 and 8 and associate them with specific output destinations as needed.
Configurations for each output destinations function independently and take effect only after the
information center is enabled.
Table 7 Information channels and output destinations
Information
channel number
Default channel
name
Default output
destination
Description
0 console Console Receives log, trap and debugging information.
1 monitor Monitor terminal
Receives log, trap and debugging information,
facilitating remote maintenance.
2 loghost Log host
Receives log, trap and debugging information
and information will be stored in files for future
retrieval.
3 trapbuffer Trap buffer
Receives trap information, a buffer inside the
device for recording information.
4 logbuffer Log buffer
Receives log and debugging information, a
buffer inside the device for recording
information.
5 snmpagent SNMP module Receives trap information.
6 channel6 Web interface Receives log information.
7 channel7 Not specified Receives log, trap, and debugging information.
8 channel8 Not specified Receives log, trap, and debugging information.
9 channel9 Log file Receives log, trap, and debugging information.