R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

59
vv
This field identifies the version of the log, and has a value of 10.
It exists only in logs sent to the log host.
module
This field specifies the source module name. You can execute the info-center source ? command in system
view to view the module list.
level (severity)
System information is divided into eight severity levels, from 0 to 7. See Table 6 for more information
about severity levels. You cannot change the system information levels generated by modules. However,
you can use the info-center source command to control the output of system information based on severity
levels.
digest
This field briefly describes the content of the system information. It contains a string of up to 32 characters.
For system information destined to the log host:
• If the character string ends with (l), the information is log information
• If the character string ends with (t), the information is trap information
• If the character string ends with (d), the information is debugging information
For system information destined to other destinations:
• If the time stamp starts with a percent sign (%), the information is log information
• If the time stamp starts with a pound sign (#), the information is trap information
• If the time stamp starts with an asterisk (*), the information is debugging information
serial number
This field indicates the serial number of the device that generates the system information. It is displayed
only when the system information is sent to a log host in the format of UNICOM.
source
This optional field identifies the source of the information. It is displayed only when the system information
is sent to a log host in HP format. It can take one of the following values:
• Slot number of a card
• IP address of the log sender
content
This field provides the content of the system information.
Information center configuration task list
Task Remarks
Outputting system information to the console Optional
Outputting system information to the monitor terminal Optional
Outputting system information to a log host Optional