R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

62
Enabling system information output to the monitor terminal
Ste
p
Command Remarks
1. Enable the monitoring of
system information on a
monitor terminal.
terminal monitor
Enabled on the console and
disabled on the monitor
terminal by default.
2. Enable the display of
system information on
the monitor terminal.
• Enable the display of debugging
information on a monitor terminal:
terminal debugging
• Enable the display of log information on a
monitor terminal:
terminal logging
• Enable the display of trap information on
a monitor terminal:
terminal trapping
Optional.
By default, the monitor
terminal only displays log and
trap information.
Outputting system information to a log host
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See Table 7 for default channel
names.
4. Configure a system
information output rule for the
log host.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "Default output rules of system
informati
on."
5. Specify the source IP address
for the log information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source IP address of
output log information is the
primary IP address of the matching
route's egress interface.
6. Configure the format of the
time stamp for system
information output to the log
host.
info-center timestamp loghost
{ date | iso | no-year-date |
none }
Optional.
date by default.
7. Set the format of the system
information sent to a log host
to UNICOM.
info-center format unicom
Optional.
HP by default.