R3721-F3210-F3171-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

64
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See Table 7 for
default channel
names.
4. Configure the channel
through which system
information can be output to
the log buffer and specify the
buffer size.
info-center logbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
Optional.
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is 512.
5. Configure a system formation
output rule for the log buffer.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "Default output rules of system
informati
on."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the SNMP module
The SNMP module only receives trap information, and discards log and debug information.
To monitor the device running status, trap information is usually sent to the SNMP network management
system (NMS). For this purpose, you must configure output of traps to the SNMP module, and set the trap
sending parameters for the SNMP module. For more information about SNMP, see "Configuring SNMP."
To configure to output system information to the SNMP module:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See Table 7 for
default channel
names.
4. Configure the channel
through which system
information is output to the
SNMP module.
info-center snmp channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).