R3721-F3210-F3171-HP High-End Firewalls VPN Configuration Guide-6PW101

113
Figure 79 Network diagram
Configuration procedure
NOTE:
Before configuring an IPv6 over IPv6 tunnel, make sure that Router A and Router B are reachable to each
other.
• Configure Router A:
# Enable IPv6.
<RouterA> system-view
[RouterA] ipv6
# Configure an IPv6 address for GigabitEthernet 0/1.
[RouterA] interface gigabitethernet 0/1
[RouterA-GigabitEthernet0/1] ipv6 address 2002:1::1 64
[RouterA-GigabitEthernet0/1] quit
# Configure an IPv6 address for GigabitEthernet 0/2 (the physical interface of the tunnel).
[RouterA] interface gigabitethernet 0/2
[RouterA-GigabitEthernet0/2] ipv6 address 2002::11:1 64
[RouterA-GigabitEthernet0/2] quit
# Create interface Tunnel 1.
[RouterA] interface tunnel 1
# Configure an IPv6 address for interface Tunnel 1.
[RouterA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode.
[RouterA-Tunnel1] tunnel-protocol ipv6-ipv6
# Configure a source address for interface Tunnel 1 (IP address of GigabitEthernet 0/2).
[RouterA-Tunnel1] source 2002::11:1
# Configure a destination address for interface Tunnel 1 (IP address of GigabitEthernet 0/2 of
Router B).
[RouterA-Tunnel1] destination 2002::22:1
[RouterA-Tunnel1] quit
# Configure a static route from Router A through interface Tunnel 1 to Group 2.
[RouterA] ipv6 route-static 2002:3:: 64 tunnel 1
• Configure Router B:
# Enable IPv6.
<RouterB> system-view