R3721-F3210-F3171-HP High-End Firewalls VPN Configuration Guide-6PW101

403
Item Descri
p
tion
Keepalive Settings
Keepalive
Interval
Set the interval and the maximum number of attempts for a VAM client
to send keepalive packets to the VAM server.
After a client successfully registers with the server, the server sends the
keepalive settings in a registration response to the client. The client then
periodically sends keepalive packets to the server and the server, after
receiving the keepalive packets, sends responses to the clients. If the
server does not receive any keepalive packet from the client within a
specific period (keepalive interval × keepalive retries), the server
deletes the client’s information and logs off the client.
IMPORTANT:
In a VPN domain, all clients use the same keepalive settings. If you
change the keepalive settings of the server, the new settings are sent to
only clients that register later; all clients registering before use the old
settings.
Keepalive
Retries
Hub Settings
Hub 1 Pirate IP
Configure IP addresses for Hubs. You can configure up to two Hubs in
a VPN domain.
IMPORTANT:
The public IP address is optional. When a Hub registers, the VAM server
will get the public address of the Hub and then send the public-private
address mapping to other clients. If you specify both the private and
public addresses of a Hub on the server, the server considers a client a
valid Hub only when both the public and private addresses that the client
registers with the server match those specified on the server.
Hub 1 Public IP
Hub 2 Pirate IP
Hub 2 Public IP
Figure 302 Adding an ISP domain
Table 63 Configuration items
Item Descri
p
tion
ISP Domain Name Enter a name for the ISP domain.