Brocade Web Tools Administrator's Guide v6.1.0 (53-1000606-02, June 2008)

116 Web Tools Administrator’s Guide
53-1000606-02
Managing zoning with Web Tools
9
If the zoning database size exceeds the maximum allowed, you cannot save the changes. The
zoning database summary displays the maximum zoning database size (see “Displaying zone
configuration summaries” on page 126).
This action updates the entire contents of the Zone Administration window, not just the selected
zone, alias, or configuration. You can save your changes at any time during the Zone Administration
session.
1. Make the zoning changes in the Zone Administration window.
2. Click Zoning Actions> Save Config.
NOTE
If you have made changes to a configuration, you must enable the configuration before the changes
will be effective. To enable the configuration, see “Enabling zone configurations” on page 124.
Select a zoning view
You can choose how zoning elements are displayed in the Zone Administration window. The zoning
view you select determines how members are displayed in the Member Selection List panel (see
Figure 52). The views filter the fabric and device information displayed in the Member Selection
List for the selected view, making it easier for you to create and modify zones, especially when
creating “hard zones.”
Depending on the method you use to zone, certain tabs might or might not be available in the Zone
Administration window.
There are two views of defining members for zoning:
• Fabric View—Displays the physical hierarchy of the fabric, a list of the attached and imported
physical devices (by WWN), and a list of the FC Virtual Initiators on switches that support iSCSI.
In the Fabric View, you can select ports for port-based zoning or devices for WWN-based
zoning.
• Devices Only—Displays a list of the attached and imported physical devices by WWN. You
cannot select ports for port-based or mixed zoning schemes, nor can you select virtual
initiators for iSCSI FC Zone creation.
1. Launch the Zone Administration window as described on page 112.
2. Click View> Choose Fabric Resources View.
3. Choose the way you want to view the fabric resource and click OK.