Brocade Web Tools Administrator's Guide v6.1.0 (53-1000606-02, June 2008)

Web Tools Administrator’s Guide 239
53-1000606-02
Configuring CUP port connectivity
19
4. Click the CUP Port Connectivity subtab.
Creating or Editing CUP Port Connectivity Configurations
Use the following procedure to create a new CUP port connectivity configuration or to edit an
existing configuration.
1. Display the CUP port connectivity configuration list.
2. You can either create a new configuration or edit an existing configuration.
To create a new configuration, click New.
The Create Port CUP Connectivity Configuration dialog box displays all ports and port
names on the selected switch (similar to the dialog box shown in Figure 109). The Block
column, Prohibit column, and prohibited ports matrix are displayed as empty, for you to
configure.
To edit an existing configuration, click the configuration and then click Edit.
The Edit Port CUP Connectivity Configuration dialog box displays the content of the
selected configuration from the switch in a table format (see Figure 109).
3. Optional: Select the check box corresponding to a port you want to block on the Block column.
Repeat this step for all ports you want to block. Select the Block All check box to block all ports.
4. Optional: Select the check box corresponding to a port you want to prohibit on the Prohibit
column. Repeat this step for all ports you want to prohibit. Select the Prohibit All check box to
prohibit all ports.
The cells in the matrix are updated with “X” icons to identify prohibited ports.
5. Optional: Click the individual cells corresponding to the combination of ports you want to
prohibit. You cannot prohibit a port to itself.
6. Review your changes. A blue background in a cell indicates that its value has been modified.
7. After you have finished making changes, do any of the following:
Click Activate to save the changes and make the configuration active immediately, as
described in Activating a CUP Port Connectivity Configuration on page 240.
Click Save to save the changes but not make the configuration active.
Click Save As to save the configuration to a new configuration file. When you click Save As,
a dialog box displays in which you should type a file name and description for the
configuration file.
Click Refresh to refresh the information from the switch.
Click Cancel to cancel all changes without saving.