Brocade Web Tools Administrator's Guide v6.1.0 (53-1000606-02, June 2008)

38 Web Tools Administrator’s Guide
53-1000606-02
Changing system configuration parameters
3
Changing system configuration parameters
You must disable the switch before you can configure fabric parameters.
You can change the following system configuration parameters:
• Switch fabric settings
• Virtual channel settings
• Arbitrated loop parameters
• System services
• Signed firmware
Configuring fabric settings
1. Open the Switch Administration window as described on page 31.
2. Disable the switch as described in “Enabling and disabling a switch” on page 36.
3. Click the Configure tab.
4. Click the Fabric subtab.
FIGURE 20 Configure tab, Fabric subtab
5. Make the fabric parameter configuration changes.
6. Click Apply.
7. Ena bl e t he sw i t c h as described in “Enabling and disabling a switch” on page 36.